R-HAC-V Hammer-In with Rebar
Heavy duty anchor with small spacing and edge distances, simply installed by hammering the stud or rebar
Features and benefits
- Approved for use with rebar in non-cracked concrete (ETAG001 Option 7)
- High performance anchor, for use in safety critical applications
- The system relies on the adhesion between concrete and resin, which is free from expansion forces. This makes it an ideal choice where close edge and spacing distances are required
- Capsule contains precise amounts of ingredients making it a very consistent product
- Adhesive bond strength is not affected by unpolluted water
- Suitable for dry or wet non-cracked concrete
- Ideal for starter bar applications
- Low cost tooling required for installation, quick and easy to install
- Styrene free - virtually odourless
Installation guide
- Drill hole to the required diameter and depth for stud size being used.
- Clean the hole with brush and hand pump at least four times each. It is very important and necessary before installation.
- Insert capsule into the hole.
- The stud is simply hammered through the capsule using a manual or mechanical hammer (M16-M30).
- Leave the anchor undisturbed unitl the curing time elapses.
- Attach fixture and tighten the nut to the required torque.
Download
Product Card
Approvals and reports
