R-HAC-V Hammer-In with Threaded Rods

Heavy duty anchor with small spacing and edge distances, simply installed by hammering the stud or rebar

High performance anchor, for use in safety critical applications
The system relies on the adhesion between concrete and resin, which is free from expansion forces. This makes it an ideal choice where close edge and spacing distances are required
Capsule contains precise amounts of ingredients making it a very consistent product
Adhesive bond strength is not affected by unpolluted water
Suitable for dry or wet non-cracked concrete
Low cost tooling required for installation, quick and easy to install
Styrene free - virtually odourless
Approved for use with threaded rods in non-cracked concrete (ETAG001 Option 7)

Base material

Non-cracked concrete C20/25-C50/60

For use also with

Natural Stone

Applications

Balustrading & handrails

Cable trays

Guard rails

Heavy machinery

Threaded rods

Cladding restraints

Curtain walling

Fencing & gates manufacturing and installation

Reinforcement bars

Installation guide

Drill hole to the required diameter and depth for stud size being used.
Clean the hole with brush and hand pump at least four times each. It is very important and necessary before installation.
Insert capsule into the hole.
The stud is simply hammered through the capsule using a manual or mechanical hammer (M16-M30).
Leave the anchor undisturbed unitl the curing time elapses.
Attach fixture and tighten the nut to the required torque.

Product Card Approvals and reports

BACK

Trust & Innovation