R-KER with Post-Installed Rebars
High performance vinylester resin approved for use with post-installed rebar connections
Features and benefits
- Approved for use with post-installed rebars in non-cracked concrete (ETAG001 Option 7)
- Suitable for use in low temperatures (down to -20°C for winter option) enables use throughout the year
- Winter version can be used in warmer temperatures for faster curing
- Suitable for use in dry and wet substrates as well as holes and substrates covered with water
- Rapid bonding time enables quick execution of works
- Very high load capacity
- Anchor does not generate tensions in the substrate which enables R-KER to be specified where closer edge and spacing distances are required
- Suitable for multiple use. Partly used product can be reused after fitting new nozzle
Applications
- Canopies
- Barriers
- Formwork installation
- Formwork support systems
- Securing formwork
- Safety barriers
- Reinforcement bars
- Road Signs
- Rebar
- Platforms
Installation guide
- Drill hole to the required diameter and depth for rebar size being used.
- Clean the hole with brush and hand pump at least four times each. It is very important and necessary before installation.
- Insert cartridge into gun and attach nozzle.
- Dispense to waste until even colour is obtained.
- Insert the mixing nozzle to the far end of the hole and inject resin, slowly withdrawing the nozzle as the hole is filled to 2/3 of its depth.
- Immediately insert the rebar, slowly and with slight twisting motion. Remove anyexcess resin around the hole before it sets and leave it undisturbed until the curing time elapses. Attach fixture and tighten the nut to the required torque.
Download
Product Card
Approvals and reports
