Trust & Innovation

Rawlplug

  1. Products
  2. Bonded Anchors
  3. Injection Cartridges Systems
  4. Vinylester Resins
  5. R-KER with Threaded Rods

R-KER with Threaded Rods

High performance vinylester resin approved for use in cracked and non-cracked concrete

Features and benefits

  • Approved for use with threaded rods for use in cracked and non-cracked concrete (ETAG001 Option 1)
  • Suitable for use in low temperatures (down to -20°C for winter option) enables use throughout the year
  • Winter version can be used in warmer temperatures for faster curing
  • Suitable for use in dry and wet substrates as well as holes and substrates covered with water
  • Rapid bonding time enables quick execution of works
  • Very high load capacity
  • Anchor does not generate tensions in the substrate which enables R-KER to be specified where closer edge and spacing distances are required
  • Suitable for multiple use. Partly used product can be reused after fitting new nozzle
Base material
  • Cracked concrete C20/25-C50/60
  • Non-cracked concrete C20/25-C50/60
Applications
  • Curtain walling
  • Balustrading
  • Handrails
  • Canopies
  • Large panel reinforcing system -Copy Eco
  • Cable conduits and trays
  • Fencing & gates manufacturing and installation
  • Pipework/ductwork supports
  • Platforms
  • Pipelines systems
  • Passenger lifts
Installation guide
  1. Drill hole to the required diameter and depth for stud size being used.
  2. Clean the hole with brush and hand pump at least four times each. It is very important and necessary before installation.
  3. Insert cartridge into gun and attach nozzle.
  4. Dispense to waste until even colour is obtained.
  5. Insert the mixing nozzle to the far end of the hole and inject resin, slowly withdrawing the nozzle as the hole is filled to 2/3 of its depth.
  6. Immediately insert the stud, slowly and with slight twisting motion. Remove any excess resin around the hole before it sets and leave it undisturbed until the curing time elapses.
  7. Attach fixture and tighten the nut to the required torque.

Download

Product Card Approvals and reports